2.1.2 Installation and uninstallation (under UNIX OS)
This section describes the procedures for uninstalling and installing UNIX-compliant JP1/AJS3 for EAP.
JP1/AJS3 for EAP is designed for use with a TCP/IP network configuration. Confirm the machine environment at the installation site before installing JP1/AJS3 for EAP.
- Organization of this subsection
(1) Installing
To install JP1/AJS3 for EAP, follow the procedure below.
(a) Prepare for installer startup
-
Log in as a superuser or issue the su command to switch from a user to a superuser.
-
Make sure that JP1/AJS3 for EAP is not running.
-
Insert the supplied JP1/AJS3 for EAP media into the drive.
(b) Start Hitachi PP Installer
Start Hitachi PP Installer using the following command:
- For HP-UX
-
# /usr/sbin/mount -F cdfs -r device-filename /cdrom
# /cdrom/IPFHPUX/setup /cdrom
- For Solaris
-
# /cdrom/SOLARIS/setup /cdrom/cdrom0
Note
If the OS is Solaris, you do not need to execute the mount command.
- For AIX
-
# /usr/sbin/mount -F cdrfs -r device-filename /cdrom
# /cdrom/AIX/setup /cdrom
When Hitachi PP installer starts, the initial window of Hitachi PP Installer appears.
(c) Install
-
In the initial window, enter I.
A list of the software that can be installed appears.
-
Move the cursor to JP1/AJS3 for Enterprise Applications and press the space bar to select it.
-
Enter I to install JP1/AJS3 for EAP.
-
Enter Y or y.
The Installer installs JP1/AJS3 for EAP.
When installation is completed, enter Q to return to the initial screen.
For details about directories created during installation, see A. Directory List.
When the installation ends normally, perform the setup procedures required to use JP1/AJS3 for EAP.
(2) Uninstalling
To uninstall JP1/AJS3 for EAP, follow the procedure below.
-
Log in as a superuser or issue the su command to switch from a user to a superuser.
-
Check that JP1/AJS3 for EAP is not running.
-
Execute the following command to start Hitachi PP Installer.
# /etc/hitachi_setup
When you start Hitachi PP Installer, the Hitachi PP Installer initial window opens.
-
In the initial window, enter D.
A list of uninstallable software programs appears.
-
Position the cursor on JP1/AJS3 for Enterprise Applications and press the space bar to select it.
-
Enter D.
-
Enter Y or y.
The Installer uninstalls JP1/AJS3 for EAP.
Once uninstallation is complete, enter Q. The initial window reappears.