2.1.1 Installation and uninstallation (under Windows)
This section describes the procedures for uninstalling and installing Windows-compliant JP1/AJS3 for EAP.
JP1/AJS3 for EAP is designed for use with a Transmission Control Protocol/Internet Protocol (TCP/IP) network configuration. Confirm the machine environment at the installation site before installing JP1/AJS3 for EAP.
The following operations require you to log in as a user granted the Administrators authority. Furthermore, if the OS's User Account Control (UAC) is enabled, you need to start the installer from the administrator console.
Once you have installed JP1/AJS for EAP, you need to restart the system to use the product.
- Organization of this subsection
(1) Installing
To install JP1/AJS3 for EAP:
-
Insert the disk supplied with JP1/AJS3 for EAP in the drive.
The initial screen opens. Follow the on-screen instructions to install JP1/AJS3 for EAP.
If a message appears requesting a restart, restart the system.
If you are using JP1/Software Distribution, you can remotely install JP1/AJS3 for EAP. For instructions on how to perform remote installation, see the manual Job Management Partner 1/Software Distribution Administrator's Guide Volume 1, for Windows systems.
When the installation ends normally, perform the setup procedures required to use JP1/AJS3 for EAP.
- Note:
-
If the following two conditions are met, you need to update the custom job definition program registered in JP1/AJS - View after installing JP1/AJS3 for EAP:
-
JP1/AJS2 for EAP or JP1/AJS3 for EAP is upgraded.
-
Windows version of JP1/AJS - View was used to define a custom job.
Perform Procedure 1 described in 3.1.1 Procedures for executing R/3 jobs and Procedure 1 described in 3.2.1(1) If JP1/AJS - View is installed on a Windows machine again.
-
For details about directories created after product installation, see A. Directory List.