3.4.4 Notes on changing IP addresses

If you change the IP address of a host in a system where JP1/AJS3 - Print Option is linked with JP1/AJS3 - View, take the following measures in addition to those required by JP1/Base, JP1/AJS3, and JP1/AJS3 - View:

1. Before changing the IP address, stop the following JP1/AJS3 - Print Option Manager License service:

   JP1/AJS3 POML service

2. Make sure that the service has stopped, and then change the IP address.

3. If you are changing from an IPv4 address to an IPv6 address, open the jprpoml.ini file and add the following definition:

   [common]
   IPv6connect = 1

   For details on the location of the jprpoml.ini file, see D.2 Product file information for JP1/AJS3 - Print Option Manager License.

   Notes:

   • If you are using a non-Administrator account in a Windows Server 2012 or Windows Server 2008 environment with User Account Control (UAC) enabled, promote the account to administrator status before editing the jprpoml.ini file.

   • Only Windows 8.1, Windows Server 2012, Windows 8, Windows 7, Windows Server 2008 R2, and Linux support the use of IPv6 addresses.

   • The default setting for IPv6connect in the jprpoml.ini file is as follows:

     In Windows Server 2012, Windows Server 2008, and Linux:

     IPv6connect = 1

     In Windows Server 2003, AIX, Solaris, and HP-UX:

     IPv6connect = 0

4. Restart the service you stopped in step 1.

5. If you changed from an IPv4 address to an IPv6 address, add the -6 option to the startup command in JP1/AJS3 - View.

   For details on setting the startup command in JP1/AJS3 - View, see 3.4.2 JP1/AJS3 - View setup.

If you are not linking JP1/AJS3 - Print Option with JP1/AJS3 - View, you do not need to do any of the above when you change the IP address.

To Page Top