1.3.2 Linkage with JP1/OJE for VOS3
- Limit values
-
For a JP1/OJE for VOS3 system, you can use the following commands:
jpqendjobshow, jpqjobcan, jpqjobget, jpqjobshow, jpqjobsub, jpqqueshow and ajsdefine (QUEUE job definition information in a unit definition file)
The following table shows the limit values for the above commands.
- Cautionary note
-
Before starting linkage with JP1/OJE for VOS3, you must use the jpqreguser command to register user information (for the VOS3 user corresponding to the login user for command execution) in the host from which you will submit the job.
For details on the jpqreguser command, see jpqreguser in 2. Commands Used during Setup in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 2.