8.8.1 Adding, deleting, or changing a execution agent
You can add and delete an execution agent during JP1/AJS3 operation. You can also change the maximum number of concurrently executable jobs on the execution agent and the status of job transfer restrictions for the execution agent.
You can also add and delete an execution agent group used for load balancing.
To perform these operations, use the following commands. For details about the commands, see 2. Commands in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 1.
-
ajsagtadd
Adds an execution agent. At the same time, this command sets the maximum number of concurrently executable jobs.
This command also adds an execution agent group.
-
ajsagtdel
Deletes an execution agent or an execution agent group.
-
ajsagtalt
Changes the execution agent information. The following information can be changed:
-
Execution host name (agent host name)
-
Maximum number of concurrently executable jobs
-
Description
-
The status of job transfer restrictions for the execution agent
You can also change information about an execution agent group. The following types of changes are possible:
-
Changing the description
-
Adding or deleting an execution agent to an execution agent group
-
Changing the execution agent priority defined in the execution agent group
-
Changing the status of job transfer restrictions for the execution agent group
-
To check the information and status of an execution agent, you can use the ajsagtshow command.
If you want to change an IP address that begins with the execution host name during operation of JP1/AJS3, see 8.9.2 Changing the IP address of the host that runs JP1/AJS3.