H.8 Procedure for replicating a virtual machine after installing JP1/AJS3 - Agent (on the original VM)
This appendix describes the procedure for replicating a virtual machine (after installing JP1/AJS3 - Agent) that must be performed on the original virtual machine.
-
Install JP1/Base on a virtual machine.
For details about the installation procedure, see the Job Management Partner 1/Base User's Guide.
-
Set up JP1/Base.
For details about the setup procedure, see the Job Management Partner 1/Base User's Guide.
-
Install JP1/AJS3 - Agent on the virtual machine.
For details about the installation procedure, see 2.2.2 Installing a JP1/AJS3 series program ( in Windows), or 12.2 Installing JP1/AJS3 series programs ( in UNIX).
-
Start the JP1/AJS3 service, and make sure that no error messages were output to the integrated trace log.
- Cautionary note:
-
After the JP1/AJS3 service starts, do not execute jobs on the agent host.
-
Stop the JP1/AJS3 service.
-
Perform the tasks that are required in JP1/Base before the virtual machine is replicated as a disk copy installation.
For the tasks that must be performed in JP1/Base during disk copy installation, see the Release Notes of JP1/Base.
-
Disable automatic startup of the JP1/Base and JP1/AJS3 services.
Disable automatic startup of the JP1/Base and JP1/AJS3 services on the replicated virtual machine.
For details about how to disable automatic startup of the JP1/Base service, see the Job Management Partner 1/Base User's Guide.
For details about how to disable automatic startup of the JP1/AJS3 service, see 4.2.4 Settings for starting and stopping JP1/AJS3 services automatically in the Job Management Partner 1/Automatic Job Management System 3 System Design (Configuration) Guide.
-
Make sure that the JP1/Base and JP1/AJS3 services, as well as related services, are not running, and then shut down the virtual machine.
-
Replicate the virtual machine.
For details about how to replicate a virtual machine, see the documentation for the virtualization software.