H. Procedure for Replicating a Virtual Machine on which JP1/AJS3 Is Installed and Set Up

This appendix describes the procedure for replicating a virtual machine after installation or setup of JP1/AJS3 - Manager or JP1/AJS3 - Agent. For an overview of how to replicate a virtual machine on which JP1/AJS3 is installed, see F. Replicating a Virtual Machine on which JP1/AJS3 Is Installed and Set Up in the Job Management Partner 1/Automatic Job Management System 3 System Design (Configuration) Guide.

The procedure for replicating a virtual machine on which JP1/AJS3 - Manager or JP1/AJS3 - Agent is installed varies depending on whether replication is being performed after installation or after setup. The following table gives the locations where the replication procedures are described in this manual.

Table H‒1: Locations where virtual machine (VM) replication procedures are described
Time of replication	Location
Time of replication	Overview	Procedure on the original VM	Procedure on the replicated VM
After installation of JP1/AJS3 - Manager	Section H.1	Section H.2	Section H.3
After setup of JP1/AJS3 - Manager	Section H.4	Section H.5	Section H.6
After installation of JP1/AJS3 - Agent	Section H.7	Section H.8	Section H.9
After setup of JP1/AJS3 - Agent	Section H.10	Section H.11	Section H.12

Note that only Windows and Linux support replication of virtual machines on which JP1/AJS3 is installed.

Organization of this section

To Page Top