3.10.4 Stop the virtual server (repeated flow)
Flow specification details
The following table shows the detailed specification of the flow:
|
Hierarchy |
Processing |
Plug-in |
|||
|---|---|---|---|---|---|
|
Plug-in name |
Version |
Description |
Error recovery method |
||
|
1 |
hypervGetVMState |
Obtain the virtual server status |
01.10.01 |
Obtains the virtual server status in the Hyper-V environment. |
After removing the cause of the error, run the service again. |
|
2 |
hypervShutdownVM |
Flow Plug-in |
-- |
Shuts down a virtual server in the Hyper-V environment. |
-- |
|
2-1 |
Standard Output Plug-in |
01.00.00 |
Outputs the value of the variable. |
After removing the cause of the error, run the service again. |
|
|
2-2 |
Compatible Plug-in |
-- |
Sets a value in the variable used for determination. |
After removing the cause of the error, run the service again. |
|
|
2-3 |
Compatible Plug-in |
-- |
Determines if the virtual server is in a state other than "Stop completed". |
After removing the cause of the error, run the service again. |
|
|
2-4 |
Shut down a virtual server |
01.10.01 |
If the virtual server is in a state other than "Stop completed", shuts down the virtual server. |
After removing the cause of the error, run the service again. |
|