8.3 Procedure to uninstall JP1/AO (non-cluster system)
Uninstallation of JP1/AO is initiated from Programs and Features in the Control Panel.
To uninstall JP1/AO:
-
In the Windows Control Panel, click Programs and then Programs and Features. In the window that appears, select JP1/AO, and then click Uninstall.
-
Specify whether to start services after uninstallation is complete, as prompted by the wizard.
-
Uninstall JP1/AO.
-
Uninstall JP1/AO - Contents and JP1/AO Content Set.
If the following warning dialog box appears while you are uninstalling, you must restart the system:
An attempt to uninstall has failed. An attempt to delete several files has failed. Reboot the system after uninstallation ends.
If you install Hitachi Command Suite products without restarting the system, there is a risk that files required for the operation of Hitachi Command Suite products might be deleted when the system restarts after installation.
- Important note
-
If Common Component is on a different server than JP1/AO, a warning message is output if an attempt to delete authentication data fails during the uninstallation. In this case, after confirming that Common Component is running, delete the authentication data by executing the hcmdsintg command.
Results of procedure
-
JP1_Automatic Operation is removed from All Programs in the Start menu.
-
If Common Component is also uninstalled when JP1/AO is uninstalled, programs for which firewall exceptions were registered are released.
Related topics