6.3.4 Procedure to perform an overwrite installation of JP1/AO on the standby server (cluster system)

Perform an overwrite installation of JP1/AO on the standby server.

To perform an overwrite installation of JP1/AO on the standby server:

1. Use the cluster software to move the resource group where the JP1/AO service is registered to the standby server.

2. If the service (JP1/Base_logical-host-name) is online on the standby server, bring it offline.

3. Start the service (JP1/Base) on the standby server.

4. Perform an overwrite installation of JP1/AO on the standby server.

5. In the Tasks window, check the tasks. If any tasks are in execution status (In Progress, Waiting for Response, Abnormal Detection, or Terminated), stop execution of the tasks or wait until the task status changes to the ended status.

6. If the HAutomation Engine Web Service is running on the standby server, stop it by executing the hcmdssrv command with the /stop /server AutomationWebService option specified.

7. Execute the setupcluster command on the standby server.

To Page Top