6.3.3 Procedure to perform an overwrite installation of JP1/AO on the active server (cluster system)

Perform an overwrite installation of JP1/AO on the active server.

To perform an overwrite installation of JP1/AO on the active server:

1. Use the cluster software to move the resource group where the JP1/AO service is registered to the active server.

2. If the service (JP1/Base_logical-host-name) is online on the active server, bring it offline.

3. Start the service (JP1/Base) on the active server.

4. Perform an overwrite installation of JP1/AO on the active server.

5. In the Tasks window, check the tasks. If any tasks are in execution status (In Progress, Waiting for Response, Abnormal Detection, or Terminated), stop execution of the tasks, or wait until task status changes to the ended status.

6. If the HAutomation Engine Web Service is running on the active server, stop it by executing the hcmdssrv command with the /stop /server AutomationWebService option specified.

7. Execute the setupcluster command on the active server.

To Page Top