5.7.2 Setting the completed-action linkage function
The completed-action linkage function automatically changes the status of monitoring objects according to the JP1 event handling status.
This function simplifies Central Scope operations because it changes the status of monitoring objects according to the JP1 event handling status, thereby eliminating the need to change the status of monitoring groups manually.
In the case of a new installation, this setting is enabled. If the setting was disabled under an old version of JP1/IM - Manager or JP1/IM - Central Scope, it remains disabled. You should change the setting as appropriate to your operation.
To set the completed-action linkage function:
-
Terminate JP1/IM - Manager.
-
Execute the jbssetcnf command using one of the following files as the argument as appropriate:
To enable the completed-action linkage function: action_complete_on.conf
To disable the completed-action linkage function: action_complete_off.conf
When you execute the jbssetcnf command, the setting is applied to the JP1 common definition information.
For details about the jbssetcnf command, see the Job Management Partner 1/Base User's Guide.
- About the setting in the file:
-
For details about the setting in the file, see Settings file for the completed-action linkage function (action_complete_xxx.conf) in 2. Definition Files in the manual Job Management Partner 1/Integrated Management - Manager Command and Definition File Reference.
-
Start JP1/IM - Manager.