12.3.7 Configuration with JP1/IM - Rule Operation
By linking JP1/IM - Manager with JP1/IM - Rule Operation, you can automatically notify JP1/IM - Rule Operation when a rule startup event (JP1 event) is issued in the system.
An example of a system configuration for this purpose is shown below.
The following products are required on each host:
- Viewer
-
-
JP1/IM - View
-
- Manager
-
-
JP1/IM - Manager
The JP1/IM - Rule Operation linkage function must be enabled.
-
JP1/Base
-
- (JP1/IM - RL host)
-
-
JP1/IM - Rule Operation
-
JP1/Base
-
- Agents
-
-
Application program, JP1-series products, and so on
-
JP1/Base
-
In this example, JP1 events related to the status of application programs and JP1 products executing on the agents are forwarded to the manager and are monitored from JP1/IM - View.
When a rule startup request event is received among the forwarded JP1 events, JP1/IM - Manager on the manager sends the request to JP1/IM - Rule Operation automatically.
JP1/IM - Rule Operation invokes the rule specified in the rule startup request. The user can check whether it was executed by accessing JP1/IM - Rule Operation from JP1/IM - View. The JP1/IM - Rule Operation host and manager can be the same server.
- Important note
-
The reporting to JP1/IM - Rule Operation is performed according to the system hierarchy (IM configuration) in the same way as for normal automated actions.
For this reason, if you want to run JP1/IM - Manager and JP1/IM - Rule Operation on different hosts, you must configure the JP1/IM - Rule Operation host at a level below the JP1/IM - Manager host.