:
[ set pd_rpl_init_start=Y|N ]
[ set pd_log_rpl_no_standby_file_opr=stop|continue ]
    :

• pd_rpl_init_start=Y|N
  Specify whether HiRDB Datareplicator linkage is to be started when HiRDB starts.
  

  Y

  Start HiRDB Datareplicator linkage when HiRDB starts. Output to the system log of data linkage information needed for HiRDB Datareplicator linkage starts at the time of HiRDB startup.

  N

  Do not start HiRDB Datareplicator linkage when HiRDB starts. You must use HiRDB's pdrplstart command to start HiRDB Datareplicator linkage. For details about how to specify the pdrplstart command, see 6.5 Handling of the source HiRDB.

• pd_log_rpl_no_standby_file_opr=stop|continue
  Specify the handling of HiRDB Datareplicator linkage if a swapping request is issued while none of the system log files can be swapped because extraction of system log information has not been completed at the source Datareplicator. This operand is applied only when HiRDB Datareplicator linkage is executed by specification of pd_rpl_init_start=Y or by execution of the pdrplstart command. This operand is not applicable to a HiRDB/Parallel Server's front-end server or dictionary server.
  

  stop

  Forcibly terminate the HiRDB unit. For details about how to restart a forcibly terminated HiRDB unit, see 6.5 Handling of the source HiRDB.

  continue

  Cancel HiRDB Datareplicator linkage and continue only HiRDB's processing. In this case, conformity between the source and target databases subject to data linkage is lost, so you must re-create the target database. For details about how to re-create a target database, see 6.5 Handling of the source HiRDB.