![[Contents]](FIGURE/CONTENT.GIF)
HiRDB Datareplicator Version 8 Description, User's Guide and Operator's Guide
![[Glossary]](FIGURE/GLOSS.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
![[Next]](FIGURE/AFTER.GIF)
To extract data from a HiRDB database, you must define in the source HiRDB definition information required to use the source Datareplicator. The table below shows the HiRDB definitions needed to use the source Datareplicator. For details about the format of the HiRDB definitions and other HiRDB-related definitions, see the HiRDB Version 9 System Definition or HiRDB System Definition manual.
Table 5-12 HiRDB definitions needed to use the source Datareplicator
| Name of definition | Format | Operand | Description | Change |
|---|---|---|---|---|
| System common definition | set format | pd_rpl_init_start | Specifies the method for starting data linkage at the source HiRDB. | -- |
| pd_log_rpl_no_standby_file_opr | Specifies the handling of data linkage if system log file swapping fails. | Y | ||
| Unit control information definition | set format | pd_rpl_hdepath | Specifies the directory used at the source Datareplicator. | -- |
Y: Operand that can be changed when HiRDB is restarted.
--: Operand that cannot be changed when HiRDB is restarted.
All rights reserved. Copyright (C) 2007, 2013, Hitachi, Ltd.