There are four types of system configurations for data linkage systems. This section explains the software configuration for each type.

• System configuration for linking data from one HiRDB to another HiRDB
• System configuration for linking data from a HiRDB to a mainframe database
• System configuration for linking data from a mainframe database to a HiRDB
• System configuration for linking data from a mainframe database to a HiRDB using a SAM file

When the source database is a HiRDB:

Install the source Datareplicator on the server machine that contains the source HiRDB's system manager and on the server machine that contains the HiRDB back-end server that contains the table to be extracted.

When the target database is a HiRDB:

Install the target Datareplicator on the server machine that contains the target HiRDB. If a HiRDB client is also installed on the same server machine, you can install the target Datareplicator on a different server machine from the target HiRDB.

The required software programs depend on the system configuration. For details about the system configurations and required software configurations, see Section 2.1 Products associated with Datareplicator.

The system configurations presented here are common to both UNIX and Windows.

Organization of this section

1.6.1 Software configuration for linking data from one HiRDB to another HiRDB

1.6.2 Software configuration for linking data from a HiRDB to a mainframe database

1.6.3 Software configuration for linking data from a mainframe database to a HiRDB

1.6.4 Software configuration for linking data from a mainframe database to a HiRDB using a SAM file