Job Management Partner 1/Software Distribution Administrator's Guide Volume 1
![[Contents]](FIGURE/CONTENT.GIF)
![[Glossary]](FIGURE/GLOSS.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
![[Next]](FIGURE/AFTER.GIF)
- When a client is installed on a Windows NT-based PC, you must log onto the OS again if you want to display the message dialog box.
- If the client's OS is Windows NT and if Client starts automatically at system boot is not selected on the Default Running Status/Polling page of the Client Setup dialog box, the message dialog box is displayed only immediately following the logon.
- If you log off or shut down a client while it is displaying the message dialog box, the same message dialog box is displayed when you log onto the client next time.
- If Run the client with non-Administrator user permissions is not selected on the Security page of the Client Setup dialog box, messages are displayed only while the user who installed the client is logged on.
- Messages received by clients are not deleted until OK in the message dialog box is clicked. Note that specifying * as the connection destination on the Connection Destination page of the Client Setup dialog box initializes the client and deletes all the messages that have been received.
All Rights Reserved. Copyright (C) 2009, 2013, Hitachi, Ltd.
Copyright, patent, trademark, and other intellectual property rights related to the "TMEng.dll" file are owned exclusively by Trend Micro Incorporated.