To change the information for connection from Information Viewer to Asset Information Manager:

1. In Information Viewer, choose File, and then Setting.
   The About Information Viewer dialog box is displayed. Change the following items, as necessary:
   
   • Host name
     Specifies the host name of the Asset Information Manager to which connection is to be made.
     
   • Port number
     Specifies the port name of the Asset Information Manager to which connection is to be made. The default is 80.
     
   • Use SSL
     Select this check box to use SSL when connecting to Asset Information Manager. By default, it is not checked.
     
   • Specify the user to be connected to Asset Information Manager.
     If you specify the user who will log in to Asset Information Manager, select the check box, and then specify that user's user ID and password.
     
   To cancel, click the Cancel button.
   
2. Click the OK button.
   The changes are enabled, and the About Information Viewer dialog box closes.
   

The figure below shows the items specified using the About Information Viewer dialog box.

Figure 6-2 About Information Viewer dialog box