Job Management Partner 1/File Transmission Server/FTP Description, Reference and Operator's Guide
Create a definition file as shown below and then specify the host names.
- Organization of this subsection
- (1) Creating a definition file
- (2) Contents of the definition file
(1) Creating a definition file
Create a definition file with the following path name:
JP1/FTP-installation-directory\FTPPASV.INI
(2) Contents of the definition file
Specify information in the format of a Windows initialization file (.ini), as shown below:
The following table lists and describes the section, keys, and values that can be specified.
Table 3-10 Contents of the definition file in the PASV mode
Section Key Value Description [PasvMode] MaxInfoCount maximum-number-of-hosts | ALL Specifies the number of remote FTP server hosts to which transmission of files in the PASV mode will be permitted:
- maximum-number-of-hosts: Specifies a maximum value for X in the HostName[X] lines that follow this line.
- ALL: Specifies that file transmission in the PASV mode is to be permitted for all remote FTP server hosts. When ALL is specified, any HostName[X] lines are ignored.
HostName[X] host-name Specifies the host name of a remote FTP server to which file transmission in the PASV mode will be permitted. Specify on a separate line each host that is to be registered.
For a host name, specify the same remote host name as is used in the transmission information.
- For X, specify a value of 1 or greater but no greater than the value of MaxInfoCount. If the specified value is greater than the value of MaxInfoCount, the specification is ignored.
- The X value on each line must be unique.
- The X values can be specified in any order.
- Examples
- Example 1: Enable transmission of files to HOST1 and HOST2 in the PASV mode:
- Example 2: Enable transmission of files to all hosts in the PASV mode:
All Rights Reserved. Copyright (C) 2010, Hitachi, Ltd.