Job Management Partner 1/Automatic Job Management System 3 - Web Operation Assistant Description, Operator's Guide and Reference

4.3.4 Items displayed in the status list

The following table lists the items in the status list that can be customized.

Table 4-4 Settings for items in the status list

Item		Setting
Host name	Display type	Display/Do not display
	Item width	Automatic/Numeric value (Units: pixels, from 1 to 1000)
Serviced name	Display type	Display/Do not display
	Item width	Automatic/Numeric value (Units: pixels, from 1 to 1000)
Unit name	Display type	Display/Do not display
	Display method	Complete display/Simple display
	Item width	Automatic/Numeric value (Units: pixels, from 1 to 1000)
	Hyperlink	Yes/No
Type		Display/Do not display
Comment	Display type	Display/Do not display
	Item width	Automatic/Numeric value (Units: pixels, from 1 to 1000)
Executing ID		Display/Do not display
Status		Display/Do not display
Hold		Display/Do not display
Delay status		Display/Do not display
Time when start delayed#1, #2		Display/Do not display
Time when end delayed#1, #2		Display/Do not display
Return value		Display/Do not display
Change plan#3		Display/Do not display
Scheduled start time		Display/Do not display
Start time		Display/Do not display
End time		Display/Do not display
Target host	Display type	Display/Do not display
	Item width	Automatic/Numeric value (Units: pixels, from 1 to 1000)
Required time		Display/Do not display

Note: Underlined values indicate defaults.

#1

Can be displayed when the server to be monitored uses JP1/AJS3 - Manager 09-00 or later or JP1/AJS2 - Manager 07-10 or later. If a version of JP1/AJS2 - Manager earlier than 07-10 is connected, the KAVI3285-E message is output, and the status cannot be displayed.

#2

You can use this item to check the result of an operation performed with the Change Delay Monitor button. We recommend you display this item if you want to use the Change Delay Monitor button.

#3

You can use this item to check the result of operation performed with the Change Time button. We recommend that you display this item if you want to use the Change Time button.

When the item width is set to Automatic, the width of the item will be set automatically to prevent the contents of the cell from wrapping around. When the width of the item is set in pixels, the contents will wrap around when they cannot fit in the cell. Note, however, that strings of alphanumeric characters will not wrap around.

When the display method of the unit name is set to Simple display, only the unit's label name will be displayed.

You cannot specify Do not display for all of the items in the status list.

[Contents][Back][Next]

Copyright (C) 2010, Hitachi, Ltd.
Copyright (C) 2010, Hitachi Software Engineering Co., Ltd.