Job Management Partner 1/Automatic Job Management System 3 Administration Guide
Specify the setting so that if an error is detected during monitoring of the JP1/AJS3 process, the cluster software fails over the JP1/AJS3 on a logical host.
If you want to try to restart the JP1/AJS3 on the same node before a failover is performed, specify the setting to restart JP1/AJS3.
Note the following if you set the cluster software to restart JP1/AJS3.
- JP1/AJS3 must be started by the cluster software, instead of by the process management of JP1/AJS3. Because the process management restarts JP1/AJS3 after an error is detected, the restart functionality might be affected and might be unable to operate correctly. To restart JP1/AJS3 more securely, the cluster software needs to perform the restart.
- In UNIX, after you stop JP1 (jajs_stop.cluster command), execute a forced stop (jajs_killall.cluster command) for clean-up and then start JP1 (jajs_start.cluster command).
- Set up JP1/AJS3 so that it starts and stops when JP1/Base starts and stops.
Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.