Job Management Partner 1/Automatic Job Management System 3 Administration Guide

[Contents][Glossary][Index][Back][Next]


8.4.2 Applying the unit definition information changed during registration for execution

To specify when changes to definitions are applied:

  1. Terminate the JP1/AJS3 scheduler service.
    Use the jajs_spmd_stop command to terminate the target JP1/AJS3 scheduler service. For details about the jajs_spmd_stop command, see jajs_spmd_stop in 2. Commands in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 1.
  2. Change the environment setting parameter.
  3. Specify an environment setting option.
    Execute the following command to change the value of the UNITDEFINERELOAD environment setting parameter to yes.
     
    jajs_config -k [JP1_DEFAULT\JP1AJSMANAGER\AJSROOT1] "UNITDEFINERELOAD"="yes"
     
    If you may change unit definitions during registration for execution, you should select Yes.
    For details about the environment setting parameters, see 2.2 Setting up the scheduler service environment in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2.
    When No is specified, the change is not applied for some units (this behavior is the same as in version 06-51 or earlier).
  4. Start the JP1/AJS3 scheduler services.
    Use the jajs_spmd command to start the target JP1/AJS3 scheduler service. If the setting that applies the unit definition information changes made during execution registration has been changed while the JP1/AJS3 scheduler service is running, restart the scheduler service. For details about the jajs_spmd command, see jajs_spmd in 2. Commands in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 1.

[Contents][Back][Next]


[Trademarks]

Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.