Job Management Partner 1/Automatic Job Management System 3 Administration Guide

[Contents][Glossary][Index][Back][Next]


8.3.1 General procedure for registering a jobnet-definition release

The following is the general procedure for registering a jobnet-definition release.

  1. Define the release-source jobnet.
    Copy a running root jobnet whose definition you want to change to any location, and define the copy as the release-source jobnet.
  2. As required, perform a pre-check of the release-source root jobnet definition.
    Use the ajschkdef command to check the definition of the release-source root jobnet. For details about the ajschkdef command, see ajschkdef in 2. Commands in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 1.
  3. Register the release.
    You register a jobnet-definition release by specifying information such as the release date and release-target jobnet. For details about such registration, see 8.3.2 Registering a jobnet-definition release.

[Contents][Back][Next]


[Trademarks]

Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.