Job Management Partner 1/Automatic Job Management System 3 Administration Guide

[Contents][Glossary][Index][Back][Next]


2.3.4 Recovering the JP1/AJS3 - Agent setup information

The following lists the tasks required to recover the JP1/AJS3 - Agent setup information of from the backup.

The following describes the tasks required to recover the JP1/AJS3 - Agent setup information from the backup.

Organization of this subsection
(1) Setting up JP1/AJS3
(2) Recovering the definition files
(3) Starting JP1/AJS3

(1) Setting up JP1/AJS3

If the JP1 environment has been damaged due to a corrupted disk or another problem, you must install JP1, set up JP1/Base, and then install the JP1/AJS3 series program in that order. For details about how to set up JP1/AJS3 - Agent, see 3.2.2 Setting up JP1/AJS3 - Agent in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1 (in Windows) or 12.2.2 Setting up JP1/AJS3 - Agent in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1 (in UNIX).

(2) Recovering the definition files

Restore the backed-up files to their original locations.

Cautionary note
Before you recover the definition files, make sure that the following conditions exist:
  1. JP1/Base is installed.
  2. JP1/AJS3 is installed.
  3. JP1 in the logical host environment has been set up (for recovery of a logical host environment).
  4. JP1/Base and JP1/AJS3 are not running.
  5. The shared disk is mounted (to recover the settings file of a logical host).

(3) Starting JP1/AJS3

After recovery, cold-start JP1/AJS3.

[Contents][Back][Next]


[Trademarks]

Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.