![[Contents]](FIGURE/CONTENT.GIF)
![[Glossary]](FIGURE/GLOSS.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
![[Next]](FIGURE/AFTER.GIF)
Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1
- Organization of this subsection
- (1) Monitoring JP1/AJS3 operation
- (2) When the embedded database is used as the database for the scheduler service
(1) Monitoring JP1/AJS3 operation
To monitor the activation status of JP1/AJS3 in a cluster system, execute the jajs_spmd_status command.
(2) When the embedded database is used as the database for the scheduler service
If the embedded database service stops due to an irrecoverable failure occurring in the service, the JP1/AJS3 service can also be stopped so that the occurrence of a failure can be detected. To enable monitoring, set the environment setting parameters as described below.
- Set the environment setting parameters.
Execute the jajs_config command to set the following environment setting parameters in the relevant scheduler service.
Environment setting parameter Value Description RDBCHECKINTERVAL 300 Checks the connection to the embedded database service and automatically stops the scheduler service if disconnection is detected. For details about the environment setting parameters, see 2.2 Setting up the scheduler service environment in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2.
For details about setting the scheduler service environment, see 13.2 Environment setting parameter settings and 16.2.3 Changing the common definition information.
Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.