Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1

[Contents][Glossary][Index][Back][Next]

14.6 Settings common to all control processes

This section describes how to change settings that are common to all control processes.

When you set environment setting parameters, use the jajs_config command.

For details about the jajs_config command, see jajs_config in 2. Commands Used during Setup in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 2.

Organization of this section
14.6.1 Settings for outputting error messages for jobs to syslog

[Contents][Back][Next]

[Trademarks]

Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.