Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1

14.5 Changing the settings related to the definition pre-check function

This section describes how to change the settings related to the definition pre-check function.

When you set environment setting parameters, use the jajs_config command.

For details about the jajs_config command, see jajs_config in 2. Commands Used during Setup in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 2.

Organization of this section

14.5.1 Setting up the JP1/AJS3 definition pre-check function

[Contents][Back][Next]

[Trademarks]