Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1
Register the JP1/AJS3 service in the cluster software to enable failover to be performed. For details about how to register the service, see the documentation for the cluster software.
Note the following when registering the service:
- Set the cluster software so that the secondary node can inherit the IP address and shared disk together with the service from the primary node. In addition, set the cluster software so that the application program is also inherited.
- Set the cluster software so that JP1/AJS3 starts after the secondary node has inherited the IP address and shared disk, and JP1/Base has started on the secondary node.
- The service name you register in the cluster software is JP1_AJS3_logical-host-name, which is registered in the environment settings.
- If you use JP1/AJS3 Console, you do not need to register the JP1/AJS3 Console service in the cluster software.
- If you use queueless jobs, see 8.2.5 Setting up the queueless job execution environment.
- After setup required for cluster system operation has been completed, before you start the first JP1/AJS3 service, check whether JP1/AJS3 Database _JFn# services have stopped. If JP1/AJS3 Database _JFn services are running, stop them, and then start the first JP1/AJS3 service. You do not need to stop JP1/AJS3 Database _JFn services again after cluster system operation has started.
- You do not need to register JP1/AJS3 Database _JFn# and JP1/AJS3 Database ClusterService _JFn# services in your cluster software.
- #:
- _JFn is the embedded database setup identifier used by JP1/AJS3 services on a logical host.
Copyright (C) 2009, 2010, Hitachi, Ltd.
Copyright (C) 2009, 2010, Hitachi Solutions, Ltd.