Job Management Partner 1/Integrated Management - Event Gateway for Network Node Manager i Description, User's Guide and Reference

3.2 Installing and setting up the logical host

This section describes installation and setup of the logical host for JP1/IM - EG for NNMi.

Before you start the procedure, check the cluster system information shown in the table below.

Table 3-1 Items to be checked before you install and set up the logical host

Item to be checked	Description
Logical host name	Name of the logical host that executes JP1
Logical IP address	IP address that corresponds to the logical host name
Shared folder (or shared directory)	Folder (or directory) on the shared disk that stores the file set for the JP1 execution environment on the logical host

For details about the prerequisites and the supported scope of cluster operation, see the Job Management Partner 1/Base User's Guide.

After you have finished checking these items, you can start installation and setup.

In Windows, install both the active server and the standby server on the same drive and in the same folders. Do not install the logical host on the shared disk.

Organization of this section

3.2.1 Installing and setting up the active server

3.2.2 Installing and setting up the standby server

3.2.3 Procedure for changing settings

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.