Job Management Partner 1/Base User's Guide

Appendix I.3 SNMP trap conversion command syntax

This section describes the command syntax used to execute the SNMP trap converter.

Organization of this subsection

(1) imevtgw_setup (Windows, HP-UX, and Solaris only)

(1) imevtgw_setup (Windows, HP-UX, and Solaris only)

Function

Register the SNMP trap converter in the NNM process management.

Format

imevtgw_setup { -d }

Required execution permission

In Windows: Administrators

In UNIX: Superuser

Storage destination directory

In Windows:

installation-folder\bin\

In UNIX:

/opt/jp1base/bin

Arguments

-d

Specifies the SNMP trap converter to be disabled.

Notes

If you want to uninstall JP1/Base, execute this command to disable the SNMP trap converter registered in the NNM process management before uninstallation.

Execute this command if a patch has been applied or if an upgrade has been performed.

Execute this command after you stop the SNMP trap converter.

If NNM is used in a cluster environment, execute this command on both the executing and standby nodes. If the NNM cluster operation method used in Windows is "direct data sharing", only execute this command on the active nodes.

[Contents][Back][Next]

[Trademarks]