Job Management Partner 1/Base User's Guide

Appendix H. Handling Changes in Communication Settings

In JP1/Base 06-71 or later, the communication settings can be changed according to the various network configurations. To change the communication settings, use the jp1hosts definition file and communication protocol settings file. (To change them for the event service, use the event server settings file (conf).) For details on the communication settings, see 4. JP1/Base Communication Settings According to Network Configurations.

The table below describes the communication settings available for the functionality offered by JP1/Base.

Table H-1 Supported functionality in communication settings

Function		Communication settings
		jp1hosts definition file	Communication protocol settings file
User management	User authentication function	Yes	Yes
	User mapping function	--	--
Startup control	Start sequence control	--	--
	Stop sequence control	--	--
Event service		No	Yes#
Event conversion	Log file trap	--	--
	Event log trap	--	--
	SNMP trap converter	--	--
Collecting and distributing definitions for the event service		Yes	Yes
Process management		--	--
ISAM utility commands		--	--
Hitachi Network Objectplaza Trace Library (HNTRLib2)		--	--

Legend:

Yes: Supported.

No: Not supported.

--: Not communicated.

#: Changed by the event server settings file (conf). (Events in JP1/SES format are not supported.)

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.