Job Management Partner 1/Base User's Guide

Appendix C.3 Connection status

The following table describes the connection status at each port number.

Table C-3 Connection status

Service name	Port number	Connection status
jp1imevt	20098/tcp	When keep-alive is specified in the remote-server parameter in the event server settings file (conf), the connection is maintained. If you want to forcibly terminate the connection, specify close in this parameter.
jp1imevtapi	20099/tcp	When keep-alive is specified in the server parameter in the API settings file (api), the connection is maintained. If you want to forcibly terminate the connection, specify close in this parameter.
jp1imrt	20237/tcp	A connection is established only when required.
jp1imcmda	20238/tcp	The connection is maintained. If the connection is forcibly terminated, you must re-execute the command.
jp1imcmdc	20239/tcp	The connection is maintained.#1 If the connection is forcibly terminated, the service is automatically reconnected.
jp1bsuser	20240/tcp	A connection is established only when required.
JP1AutoJob (in Windows) jesrd (in UNIX)	user-definable-value/tcp	A connection is established only when required.
jp1bsplugin	20306/tcp	A connection is established only when required.
jp1bscom	20600/tcp	A connection is established only when required.
ldap	389/tcp#2	A connection is established only when required.
ldaps	636/tcp#2

#1: If there is no communication for more than 30 minutes, the connection is disconnected.

#2: The port number depends on whether SSL is used for communication between JP1/Base (authentication server) and a directory server. If SSL is used, 636/tcp is used.

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.