Job Management Partner 1/Base User's Guide

Common definition settings file (local action function)

Format

[JP1_DEFAULT\JP1BASE\LCACT]
"LOGSIZE"=size-of-local-action-execution-log-file
"LOGFILENUM"=number-of-local-action-execution-log-files-to-be-saved
"PAUSE"=dword:{00000000 | 00000001}

File name

Any

jp1bs_lcact_setup.conf.model (Model file for the common definition settings file (local action function))

Storage destination directory

The model file for the common definition settings file (local action function) is located in the following directory. Copy this file to create a new file with any file name.
In Windows:
installation-folder\conf\lcact\
shared-folder\jp1base\conf\lcact\ (in a cluster system)
In UNIX:
/etc/opt/jp1base/conf/lcact/ 
shared-directory/jp1base/conf/lcact/ (in a cluster system)

Description

This file specifies the local action function to pause or unpause in order to perform maintenance. This file also specifies log information of the local action execution log file to the common definitions.

Application of settings

Execute the jbssetcnf command to register information of the common definition settings file (local action function) into the common definition information. For details on the jbssetcnf command, see jbssetcnf in 13. Commands.

Next, either execute the jbs_spmd_reload command or restart JP1/Base to apply the common definition information settings. For details on the jbs_spmd_reload command, see jbs_spmd_reload in 13. Commands.

Definition details

The following conventions apply to entries in the common definition settings file (local action function).

A hash mark (#) (code 0x23) at the start of a line indicates a comment.

Do not enter a space or tab before or after an equal sign (=) or comma (,) or at the beginning or end of a line. If a space or tab character appears in these locations, an error occurs at jbssetcnf command execution.

Lines containing only a linefeed character are ignored.

[JP1_DEFAULT\JP1BASE\LCACT]

This section specifies whether to enable the local action function and the log information of the local action execution log. To set a logical host, change JP1_DEFAULT to the logical host name.

"LOGSIZE"=size-of-local-action-execution-log-file

Specify, in bytes, the size of the local action execution log file with hexadecimal numbers. The specifiable range is 00002000 (8 KB) to 00400000 (4,096 KB). When a size smaller than the lower limit of the range is specified, the lower limit will be used. When a size larger than the upper limit of the range, the upper limit will be used. The default is 00100000 (1,024 KB).

"LOGFILENUM"=number-of-local-action-execution-log-files-to-be-saved

Specify, with hexadecimal numbers, how many of the local action execution log files you want to save. The specifiable range is 00000001 (one file) to 00000010 (16 files). When a size smaller than the lower limit of the range is specified, the lower limit will be used. When a size larger than the upper limit of the range, the upper limit will be used. The default is 00000004 (four files).

"PAUSE"=dword:{00000000 | 00000001}

Specifies whether to start the local action function or to pause the function. To start the function, specify as dword:00000000. To pause the function, specify dword:00000001. If a number out of the specifiable range is specified, the default will be used. The default is 00000000.

[Contents][Back][Next]

[Trademarks]