Job Management Partner 1/Base User's Guide

jp1hosts definition file

Format

# Comment
host-name IP-address, IP-address, IP-address

File name

jp1hosts or any other file name

Storage destination directory

In Windows:

installation-folder\conf\
shared-folder\jp1base\conf\ (in a cluster system)

In UNIX:

/etc/opt/jp1base/conf/ 
shared-directory/jp1base/conf/ (in a cluster system)

Description

This file specifies the hosts information specific for JP1/Base. The jp1hosts definition file is provided by default. This default jp1hosts definition file cannot be used without editing it. When you use the default jp1hosts definition file, you must first edit it according to the use in JP1/Base. When you create your own jp1hosts definition file, store it in the same folder as the default jp1hosts file is stored.

Application of settings

Execute the jbshostsimport command to apply the jp1hosts information to the common definition information. For details on the jbshostsimport command, see jbshostsimport in 13. Commands.

Definition details

The following conventions apply to entries in the jp1hosts definition file:

A jp1hosts definition file consists of one entry per line. The characters you enter must be no more than 255 bytes per line.

A hash mark (#) (code 0x23) at the start of a line indicates a comment.

host-name IP-address, IP-address, IP-address

This line indicates the correspondence between the host name and IP addresses. For host-name and IP-address, you can use ASCII characters only. Also, " / \ [ ] ; : | = , + ? <, and > are not allowed. host-name and IP-address must be separated by one or more spaces or tab characters. host-name cannot be a string that is recognized as an IP address.

Use a comma (,) to delimit multiple IP-addresses. The spaces and tab characters before and after the comma are ignored. Each IP address must be specified in the format of W.X.Y.Z (W, X, Y, and Z are numeric numbers from 0 to 255).

No more than four IP-addresses can be specified for one host-name. You cannot specify the same host name twice. If you do this, an error will occur when you execute the jbshostsimport command.

[Contents][Back][Next]

[Trademarks]