Job Management Partner 1/Base User's Guide

JP1/Base parameter definition file

Format

[JP1_DEFAULT\JP1BASE]
"SEND_PROCESS_TERMINATED_ABNORMALLY_EVENT"=dword:{0 | 1}
"SEND_PROCESS_RESTART_EVENT"=dword:{0 | 1}
"SEND_AUTHSRV_EVENT"=dword:{0 | 1}

File name

jp1bs_param_V7.conf

Storage destination directory

In Windows:

installation-folder\conf\
shared-folder\jp1base\conf\ (in a cluster system)

In UNIX:

/etc/opt/jp1base/conf/ 
shared-directory/jp1base/conf/ (in a cluster system)

Description

When a process ends abnormally or the authentication server is swapped over automatically in a system with two authentication servers, JP1/Base outputs an error message to the integrated trace log. This file is preset so that these messages can be issued as JP1 events.

Application of settings

Execute the jbssetcnf command to apply the settings of the JP1/Base parameter definition file (jp1bs_param_V7.conf) to the common definition information. Restart JP1/Base and the programs that require JP1/Base to apply the settings. For details on the jbssetcnf command, see jbssetcnf in 13. Commands.

Definition details

Locate the following lines in this file:

SEND_PROCESS_TERMINATED_ABNORMALLY_EVENT

Specifies whether to issue a JP1 event when a process ends abnormally or when a timeout occurs at process startup. The default is dword:0.

SEND_PROCESS_RESTART_EVENT

Specifies whether to issue a JP1 event when the process is restarted. The default is dword:0.

SEND_AUTHSRV_EVENT

Specifies whether to issue a JP1 event when the authentication server is swapped. The default is dword:0.

To enable issuing of a JP1 event at error detection, change dword:0 in both parameters to dword:1. To disable issuing of a JP1 event at error detection, change dword:1 in both parameters to dword:0.

Note

If you want to configure this file on the logical host, configure it on both the primary and secondary nodes. Replace JP1_DEFAULT in JP1_DEFAULT\JP1BASE with logical-host-name.

[Contents][Back][Next]

[Trademarks]