Job Management Partner 1/Base User's Guide

jp1base_setup (UNIX only)

Function

The jp1base_setup command sets the operating environment of JP1/Base. Execute this command before using JP1/Base, either in a cluster system or a non-cluster system.

Format

jp1base_setup

Required execution permission

Superuser

Command directory

/opt/jp1base/bin/

Notes

• If you are installing JP1/Base over an existing JP1/Base program, there is no need to set up the operating environment by executing the jp1base_setup command.
  If you reinstall JP1/Base Version 6 on a host that has JP1/IM installed, and then execute the jp1base_setup command, the values set using the jcocmddef command in JP1/IM are reset to their defaults. You will need to set the values again, using the jcocmddef command.
  
• If you execute the jp1base_setup command after setting up a logical host, the communication protocol for a physical host is set to the ANY binding method. In that case, change the communication protocol to the IP binding method, as follows:
  
  1. Create a file containing the following contents:
     [JP1_DEFAULT\JP1BASE]
     "JP1_BIND_ADDR"="IP"
     
  2. Execute the jbssetcnf command to set the above file in the common definitions.
• Do not execute this command when JP1/Base is active.

Return values

0	Normal end
1	Abnormal end

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.