Job Management Partner 1/Base User's Guide

jbsrt_distrib

Function

The jbsrt_distrib command is executed on a manager host (i.e. host on which JP1/IM - Manager is installed).

This command distributes information defined in the configuration definition file from the host on which the command is executed to lower-level hosts, and then the definitions are enabled.

If the configuration definition information has already been set, the existing configuration definition is deleted, and then the new configuration definition is distributed.

Before executing this command, JP1/Base must have started on the target lower-level hosts to which the configuration definition is distributed. If JP1/Base has not started yet on a target host, the configuration definition will not be distributed to the host. If this happens, a message is displayed during command execution, notifying you that the configuration information cannot be set. By continuing the process, the configuration definition is distributed to other hosts on which JP1/Base has started. To distribute the configuration definition to a host to which it cannot be distributed, start JP1/Base on the host, and then re-execute the jbsrt_distrib command. When a message asking you to delete the configuration definition information appears, enter n to distribute the configuration definition to the host. This completes the distribution of the configuration definition in the entire system.

The following configuration definition file is referenced by this command:
In Windows:
installation-folder\conf\route\jbs_route.conf
shared-folder\jp1base\conf\route\jbs_route.conf (when the -h option is specified)
In UNIX:
/etc/opt/jp1base/conf/route/jbs_route.conf
shared-directory/jp1base/conf/route/jbs_route.conf (when the -h option is specified)
For details on the format of the definition file, see the manual Job Management Partner 1/Integrated Management - Manager Command and Definition file Reference.

Format

jbsrt_distrib [-h logical-host-name]

Required execution permission

In Windows: Administrators (If User Account Control (UAC) for Windows is enabled, you must execute the command from the administrator console.)

In UNIX: Superuser

Command directory

In Windows:
installation-folder\bin\
In UNIX:
/opt/jp1base/bin/

Arguments

-h logical-host-name

When using JP1/Base in a cluster system, specify the logical host for which you will execute the command. If you omit this option, the host name set in the environment variable JP1_HOSTNAME is assumed. If the environment variable JP1_HOSTNAME is not set, the physical host name is assumed. There is no need to specify this argument unless you are running a cluster system.

Return values

0 Normal end

1 Abnormal end

[Contents][Back][Next]

[Trademarks]