Job Management Partner 1/Base User's Guide

jbs_stop.cluster (UNIX only)

Function

The jbs_stop.cluster command stops JP1/Base (the event service and process management including user management) in a cluster system. To execute this command, you must first register it in your cluster software.

The following commands are executed within this command:

jevstop logical-host-name

jbs_spmd_stop -h logical-host-name

Format

jbs_stop.cluster logical-host-name

Required execution permission

Superuser

Command directory

/etc/opt/jp1base/

Arguments

logical-host-name

When using JP1/Base in a cluster system, specify the logical host for which you want to execute this command.

Notes

The jbs_stop.cluster command does not stop the log-file trap management daemon, which is used on both the logical and physical hosts. You can stop the daemon by executing the jevlogdstop command after executing the jbs_stop.cluster command. However, if the log-file trap management daemon is active on the physical host, executing the jevlogdstop command will disable log file trapping on that physical host. Before executing the jevlogdstop command, make sure that the log file trapping is not being used on the physical host.

After issuing the stop request to the JP1/Base processes, this command ends with the return value 0. To check whether the processes have stopped correctly, after the jbs_stop.cluster command has finished, use the jbs_spmd_status command.
In a cluster system that monitors during stop processing, modify the command that terminates JP1/Base (the event service and process management including user management), as follows:
cd /etc/opt/jp1base 
cp -p jbs_stop.cluster.retry.model jbs_stop.cluster 

Return values

0 Normal end

1 More than one argument was specified.

[Contents][Back][Next]

[Trademarks]