Job Management Partner 1/Base User's Guide

jbs_start (UNIX only)

Function

The jbs_start command starts JP1/Base (the event service, process management including user management, and the log-file trap management daemon).

To automatically start JP1/Base by executing this command, run the following script after completing JP1/Base installation and setup:
cd /etc/opt/jp1base 
cp -p jbs_start.model jbs_start

Format

jbs_start

Required execution permission

Superuser

Command directory

/etc/opt/jp1base/

Notes

After issuing the startup request to the JP1/Base processes, this command ends with the return value 0. To verify the proper state of the processes, after the jbs_start command has finished, use the jbs_spmd_status command.

If you execute the jbs_start command as a remote shell command, you must terminate the standard input, standard output, and standard error output by assigning /dev/null to those beforehand. The remote shell command might not terminate after JP/Base processes started.

Return values

0 Normal end

1 More than one argument was specified.

[Contents][Back][Next]

[Trademarks]