![[Contents]](FIGURE/CONTENT.GIF)
![[Glossary]](FIGURE/GLOSS.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
![[Next]](FIGURE/AFTER.GIF)
Job Management Partner 1/Base User's Guide
Using the jevdbswitch command, you can initialize an event database while the event service is active. However, you must stop the event service and use the jevdbinit command to initialize an event database, if any of the following occur:
- There are not enough system resources.
- You cannot connect to the event service.
- A JP1 event is being forwarded to another event server.
The following describes the procedure for initializing an event database.
- Organization of this section
- 8.2.1 Initializing an event database while the event service is active
- 8.2.2 Initializing an event database while the event service is stopped
All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.