Job Management Partner 1/Base User's Guide
In the Windows version of JP1/Base, the following services are registered by default as Automatic and are set to start automatically at system startup:
- Hitachi Network Objectplaza Trace Monitor 2 (Hitachi Network Objectplaza Trace Library)
- JP1/Base Control Service (startup control)#
#: In a system environment with JP1/Power Monitor installed, do not set the JP1/Base Control Service to Manual. If so, the Power Monitor service might not operate correctly.
The following services are set by default to start automatically when the JP1/Base Control Service (startup control) starts:
- JP1/Base (process management including user management)
- JP1/Base Event (event service)
- JP1/Base LogTrap (Log-file trap management service)
There is normally no need to change these settings. Using the JP1/Base Control Service (startup control), you can set the JP1/Base EventlogTrap (event log trapping service) and other application programs to start automatically in a predefined sequence. For details on using the startup control, see 7. Setting the Service Start and Stop Sequences (Windows Only).
- When not using JP1/Base Control Service:
- To start a particular service without using the JP1/Base Control Service (startup control), add comment delimiters to the service definitions in the start sequence definition file (JP1SVPRM.DAT). Also, add comment delimiters to all the service definitions having dependencies with that service. That is, enter a # symbol at the beginning of every line of the definitions about the services.
- Having edited the start sequence definition file (JP1SVPRM.DAT) in this way, you can then work with that service in the Services dialog box that opens from the Control Panel in Windows. If you start the services automatically or manually without adding comment delimiters, the KAVA4003-E message might appear and the system might not operate correctly.
- Notes
- When using the startup control, do not use the Services dialog box to work with any of the services defined in the start sequence definition file (JP1SVPRM.DAT). Starting or stopping these services in the Services dialog box could cause the KAVA4003-E message to appear, and could make automatic start and stop control by the JP1/Base Control Service fail to operate correctly.
- The event service must be running before the log-file trap management service and event-log trapping service can start. Always start JP1/Base Event before JP1/Base LogTrap and JP1/Base EventlogTrap.
- The performance of programs that use the event service can be affected if JP1/Base is installed but the event service is not running. To avoid such problems, prohibit events from being issued or acquired if you do not wish to use the event service. For details, see API settings file in 14. Definition Files.
All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.