Job Management Partner 1/Performance Management User's Guide

[Contents][Glossary][Index][Back][Next]

11.2.2 Installation

To use the OpenView linkage facility, you need to install PFM - Manager or PFM - Base on a host that has NNM installed.

The following figure shows the configuration when PFM - Base is installed.

Figure 11-2 Configuration for using the OpenView linkage facility

[Figure]

For details on how to install PFM - Manager and PFM - Base, see the chapter that describes installation and setup in the Job Management Partner 1/Performance Management Planning and Configuration Guide.

[Contents][Back][Next]

[Trademarks]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.