Job Management Partner 1/Performance Management User's Guide
To delete an alarm table, you can use the jpctool alarm delete command.
To delete an alarm table:
- Log on to the host where PFM - Manager is installed.
- Execute the jpctool alarm list command to view the name of the alarm table to delete.
For example, execute the following command when you want to view the alarm table names defined in the PFM - Agent for Platform (UNIX):
The output is shown below. In this example, you can see that the monitoring template and the alarm table alarmtable1 are defined.
jpctool alarm list -key UNIX
For further details on the jpctool alarm list command, see the chapter that describes the command in the manual Job Management Partner 1/Performance Management Reference.
Product ID:U Alarm Table Name: alarmtable1 PFM UNIX Solution Alarms 6.70 PFM UNIX Solution Alarms 7.00
- Execute the jpctool alarm delete command.
For example, execute the following command when you want to delete the alarm table alarmtable1 of the PFM - Agent for Platform (UNIX):
For further details on the jpctool alarm delete command, see the chapter that describes the command in the manual Job Management Partner 1/Performance Management Reference.
jpctool alarm delete -key UNIX -table alarmtable1
- Execute the jpctool alarm list command to make sure that the alarm table has been deleted.
Like in step 2, execute the command as follows:
The output is shown below. In this example, you can see that the alarm table alarmtable1 has been deleted.
jpctool alarm list -key UNIX
For further details on the jpctool alarm list command, see the chapter that describes the command in the manual Job Management Partner 1/Performance Management Reference.
Product ID:U Alarm Table Name: PFM UNIX Solution Alarms 6.70 PFM UNIX Solution Alarms 7.00
All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.