Job Management Partner 1/Performance Management User's Guide
Use the jpcvsvr.ini file to set the authentication mode of a user account (management method).
To set the authentication mode (management method) of a user account:
- Stop the PFM - Manager and PFM - Web Console services.
Stop the services in the order of PFM - Web Console and PFM - Manager.
- Use a text editor or a similar tool to open the jpcvsvr.ini file.
The jpcvsvr.ini file is stored in the following locations:
- On physical hosts:
- In Windows:
- installation-folder\mgr\viewsvr\jpcvsvr.ini
- In UNIX:
- /opt/mgr/viewsvr/jpcvsvr.ini
- On logical hosts:
- In Windows:
- environment-directory\jp1pc\mgr\viewsvr\jpcvsvr.ini
- In UNIX:
- environment-directory/jp1pc/mgr/viewsvr/jpcvsvr.ini
- Change the value of UserServer.authenticationMode in the jpcvsvr.ini file.
The following table describes the authentication mode settings for UserServer.authenticationMode in the jpcvsvr.ini file.
Table 2-2 Authentication mode settings
Authentication mode Settings PFM authentication mode UserServer.authenticationMode=PFM JP1 authentication mode UserServer.authenticationMode=JP1
- Reference note:
- The PFM authentication mode is set if you specify an invalid value.
- Save and then close the jpcvsvr.ini file.
- Start the services of PFM - Manager and PFM - Web Console.
Start PFM - Manager, and then start PFM - Web Console.
The changed jpcvsvr.ini file is loaded, and then the authentication mode is set.
- Note:
- A message indicating an authentication error appears if, after the authentication mode is set, you logged on to PFM - Web Console by using a user account with a management method that is different from the set mode.
- Reference note:
- Overwrite the jpcvsvr.ini file with the jpcvsvr.ini.model file (in the same folder) to restore the default settings for the jpcvsvr.ini file.
All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.