Job Management Partner 1/Performance Management User's Guide

1.4.1 Configuration for synchronizing service starting and stopping

If you want to link start and stop processes by using the jpcspm command, you must modify the pfmwebcon_host.conf file.

To modify the pfmwebcon_host.conf file:

1. Use a text editor to open the pfmwebcon_host.conf file.
   The pfmwebcon_host.conf file is located in the following location:
   
   • In Windows:
     PFM-Web-Console-installation-folder\conf\
     
   • In UNIX:
     /opt/jp1pcwebcon/conf/
     
2. Edit the pfmwebcon_host.conf file and then save it.
   The format of the pfmwebcon_host.conf file is as follows. Do not enter spaces before or after the equals sign (=).
   

    
   # Operate Host
   HOST_NAME=HOSTNAME
    

   The following table describes valid values of HOSTNAME.
   

   Table 1-1 Valid values of HOSTNAME

   Value	Description
   --	Specifies that starting and stopping are not to be synchronized.
   localhost	Specifies that starting and stopping are to be synchronized in a non-cluster system environment. Use lower-case characters only.
   Logical host name	Specifies that starting and stopping are to be synchronized in a cluster system. Specify the name of the logical host running PFM - Web Console. You cannot specify an IP address. The host name is case sensitive.

   Legend

   --: No value

[Contents][Back][Next]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.