10.5.1 How to terminate the EADS servers

This subsection explains how to export data from memory caches to the store data files before terminating the EADS servers so that the data can be reused the next time the EADS servers are started.

Organization of this subsection

(1) Close the cluster
(2) Verify that the cluster is closed
(3) Terminate the EADS servers
(4) Verify that the EADS servers have been terminated

(1) Close the cluster

Execute the eztool close command to close the cluster.

eztool close

Command execution example

[Figure]

To Page Top

(2) Verify that the cluster is closed

After you have closed the EADS servers, execute the eztool status command to check the status of the cluster.

eztool status

Command execution example

[Figure]

If the cluster is closed, closed is displayed in the State column.

To Page Top

(3) Terminate the EADS servers

Execute the eztool stop command to terminate all EADS servers in the cluster after exporting the most recent data to the store data files.

eztool stop

Command execution example

[Figure]

To Page Top

(4) Verify that the EADS servers have been terminated

Check the message logs of the EADS servers.

[Figure]

To Page Top