14.3.2 close (closes the cluster)
- Organization of this subsection
(1) Description
This subcommand closes the cluster.
(2) Rules
-
This subcommand can be executed only when the status of the cluster is one of the following:
-
Cluster available (AVAILABLE)
-
Cluster partially available (PARTIALLY_AVAILABLE)
-
-
The target of this subcommand is the EADS servers whose cluster participation status is online. This subcommand cannot be executed if the cluster contains any EADS server whose cluster participation status is standby. You can determine the cluster participation status with the eztool status command.
-
This subcommand can be executed when the target EADS servers are in the following status:
-
Running
-
Closed
-
(3) Format
eztool close
(4) Return code
The following table lists the return codes that this subcommand returns.
No. |
Return code |
Description |
|
---|---|---|---|
eads.command.compat parameter omitted in the command properties |
0300 specified in the eads.command.compat parameter in the command properties |
||
1 |
0 |
0 |
Command execution was successful. |
2 |
101 |
101 |
Initialization of the command failed. |
3 |
110 |
Connection establishment failed. |
|
4 |
111 |
The command failed due to a communication timeout. |
|
5 |
120 |
The command failed due to a syntax error. |
|
6 |
130 |
The command failed because it could not be executed. |
|
7 |
131 |
The command failed because another command was executing. |
|
8 |
150 |
The command failed during execution. |
|
9 |
200 |
The command failed due to a timeout. |