Figure 3-6 shows the Installation Medium page.

Figure 3-6 Installation Medium page

The components of the Installation Medium page are as follows.

(a) Comments text box

You can enter a comment for the installation set. You can skip this text box if there is nothing to comment. You can enter no more than 128 characters. The contents you enter in this text box are displayed in Comment in the Installation sets list in the Startup Kit dialog box.

(b) Change the installation medium check box

You can select this check box when you click the Edit button in the Startup Kit dialog box. If you click the New button, you cannot select this check box. When you select this check box, the installation medium for the existing installation set is changed to the medium you specified in the Directory text box. If you do not select this check box, the installation medium is not changed.

(c) Directory text box

Use the Browse button to specify the directory in the installation medium. You can enter no more than 255 characters.

The directory you should specify depends on the type of the installation medium as shown below.

• When using the CD-ROM containing JP1/Software Distribution Client
  Use a full pathname to specify the DISK1 directory in the CD-ROM containing JP1/Software Distribution Client.
  Example: E:\CLIENT\DISK1
  
• When using the Integrated CD-ROM
  Specify the root directory of the Integrated CD-ROM.
  Example: E:\
  Note that you cannot create an installation set from the Integrated CD-ROM.