If necessary, you can specify search conditions and then click the Search button to check the count results of operation logs. For Search period, specify a period of no more than one year.

You must specify a search period. If you do not specify an end date for the search period, the date on which the search is executed is set as the search period end date.

How to use the search results

• Search patterns registered in the Operation Log List window are displayed in Search pattern. Clicking the anchor of a search pattern enables you to browse the search conditions for that search pattern.
• The period covered by the search pattern is displayed in Valid period.
• The number of operation logs detected in the count results is displayed in Number of detected logs. If the value of the ID key for operations of a device from which operation logs are collected by JP1/Software Distribution does not match any of the values registered in the asset management database, and if the device's host name is registered for more than one device, the count results that are collected may differ from the actual number, because the device from which the operation logs originate cannot be uniquely determined.
• The total number of clients for an which operation log was detected during the specified search period is displayed in Number of detected devices.
  In the window that displays the breakdown by group name, the information obtained when the jamOperationLogAddUp command was executed is displayed as is.
  

If you change the group information or IP group information after the operation logs have been counted, the count results are not updated by the changed content.