6.9.3 Notes on configuration if a management server is used as the failure management processor (model: HA8000xN or later)
If you reconfigure HA Monitor Connector when, for example, adding a host or changing the configuration, you must stop the HA Monitor programs of all HA8000 servers set on the management server.
The following shows the configuration procedure:
-
Stop the HA Monitor programs of all HA8000 servers that are set in HA Monitor Connector.
The HA8000 system units do not need to be active, but power must be supplied to them.
-
Change the settings of HA Monitor Connector.
For details, see the documentation for HA Monitor Connector.
-
Use the HA Monitor environment setup command (monsetup command) to configure the reset path.
For details about the HA Monitor environment setup command (monsetup command), see 9.22 monsetup (specifies HA Monitor environment settings).